The Signaline LocatorPlus-EN is a dual zone control monitor module for the Signaline FT-EN heat detector cables. Each zone is able to monitor 1000m of cable, meaning the LocatorPlus-En can cover a large detection area.
The Signaline LocatrPlus-EN is quick and simple to set up, and requires no specialist software or programming tools. There are two operating modes, allowing the zones to operate independently or interlocking.
When an alarm occurs, the Signaline LocatorPlus-EN immediately displays the alarm location and zone of the activation. This allows for quick and efficient alarm notification.
The Signaline LocatorPlus comes in a IP65 box making it suitable for field mounting.
Compatible with: Signaline FT-88-EN, FT-78-EN EN54-28:2016 approved
Independent or interlocking modes
Monitors 2 zones of up to 1000m each
180 x 120 x 60.5mm HxWxD
Light Grey with clear lid, Orange faceplate
2 line, 16 character backlit display showing zone status
EN54-28:2016, UL File no.: S24913
12 VDC, 24 VDC, 36 VDC
<15mA, <5mA, <7mA
<15mA, <23mA, <40mA
-20°C to +50°C
Spacing 5mm Rising Clamp
0.08mm2 (28AWG) to 4mm2 (11AWG)
Input Zone 1, Input Zone 2, Power
Up to 2 zones Signaline FT-78-EN or FT-88-EN
1 to 1000m (3280ft)
|End of Line Resistor||
3.6 kOhm (included)
|Short circuit current||
|Max Zone Voltage||
Two wire RS-485 Modbus RTU
2.4kHz 92dBa @ 10cm Buzzer
2x Form C volt-free relay contacts (resistive, common)
2x Optoisolated phototransistor output (resistive, common)